Shogun-motorsports Kawasaki Ninja 300 NON ABS (13-14) Frame Slider Instrukcja Użytkownika

Ninja 300 NON ABS (13-14) Frame Slider Installation Instructions Part Numbers: 710-4129,750-4129, 755-4129, 750-4120, 850-4120 MADE IN THE USA! Caref

READ CAREFULLY Shogun cannot guarantee that they will protect your motorcycle from any extent of damage. Shogun frame sliders are really meant to

Installation Steps: 1. If you are disassembling your Ninja 300 for the first time it’s always a good idea to have two separate trays for smaller pa

4. Remove lower body cowls left and right. Note: To remove plastic body clips use a flathead screwdriver and lightly pop out the center of clip.

5. Remove inner radiator cowl. Note: To remove body clips press the center inward to release plastic rivet. There are also two bolts that need to

6. Remove the two left and right body screws located underneath the head light assembly. 7. Remove left and right upper cowls and unclip tu

8. Remove counter shaft cover. 9. Make sure the vehicle is in a fixed secure position. With a standard floor jack support the engine enough to

10. Remove left side harness bracket. Note: The rubber coated connector has to be unplugged to be removed from bracket the other unclips from

12. After mounting the rails in step 11 install each of the 4 round finishing plugs (99-CP-4120) into each open end of the Shogun rails. 13. Usi

15. Re-assemble the bike using steps 7, 6, 5, 4, 3 and 2 in that order. 16. Mount left side puck using 10 X 1.5 X 120 (99-HB-SH101500120) bolt a